22-04-2018, 01:10 PM
Hi folks
Was thinking of putting 3mm spacers on the back to just give a smidge more clearance between the back of the tyre and the wheelarch liner. Axle is still pretty good, not much camber but I just went from 14" harriers to 15" cyclones on 195's and there's not much room there, especially as I fitted a phase 3 liner on the nearside (it's a phase 2 car which didn't come with one on that side) - the liner fits well but bulges a little.
Just wondered if I am likely to need longer bolts with just a 3mm on there? Bolts are all new and are as below. I'll check their protrusion through the wheel. Rule of thumb 1.5 x diameter ?
![[Image: s-l1600.jpg]](https://i.ebayimg.com/images/g/5ecAAOSwQcJaFZp4/s-l1600.jpg)
Was thinking of putting 3mm spacers on the back to just give a smidge more clearance between the back of the tyre and the wheelarch liner. Axle is still pretty good, not much camber but I just went from 14" harriers to 15" cyclones on 195's and there's not much room there, especially as I fitted a phase 3 liner on the nearside (it's a phase 2 car which didn't come with one on that side) - the liner fits well but bulges a little.
Just wondered if I am likely to need longer bolts with just a 3mm on there? Bolts are all new and are as below. I'll check their protrusion through the wheel. Rule of thumb 1.5 x diameter ?