24-01-2012, 04:48 PM
Updated Spec: 19/03/12
Lot of you know me already, thought I'd get a project up on here that I can keep track of.
Little background info: car started on a Lucas, loads of service history, heater matrix went within first week of owner ship so changed that, other then that a standard black DTurbo.
Spec to date - 26/12/12:
- FMIC (2.25" piping)
- Xantia inlet manifold
- Black Cyclones
- Gov'd/LDA'd Bosch
- T25 @ 28PSI (No Filter & welded WG)
- Straight through to Cherry Bomb
- 2 X Slim line fans
- Chavtastic sub woofer, amp, 6x9's etc
- 266 Brakes
Stored parts:
- Cone Air Filter x 2
- Xantia 2.25" black plastic & rubber piping
- 40mm lowering springs
- Throttle cable kit
- Lucas pump setup
- Bosch setup
- Manual boost controller
- EGR Blanking plate (Mark_Airey special)
- T2
Wanted parts:
- Bigger cone filter / BMC CDA
- Custom intake piping
Future plans are to get some bigger brakes on, get the FMIC plumbed in, turn the boost up to 24~30 PSI (along with increasing the fuel obviously) and possibly if funds permit pay someone to weld a bigger turbo on.
Heres an old picture, I need to get some new ones soon:
The beast of a FMIC that arrived today (what have I done lol)!?
Can fits in the inlet/oulet:
Comparison against a beer:
Comparison against a 32" TV:
Any comments good or bad welcomed.
Lot of you know me already, thought I'd get a project up on here that I can keep track of.
Little background info: car started on a Lucas, loads of service history, heater matrix went within first week of owner ship so changed that, other then that a standard black DTurbo.
Spec to date - 26/12/12:
- FMIC (2.25" piping)
- Xantia inlet manifold
- Black Cyclones
- Gov'd/LDA'd Bosch
- T25 @ 28PSI (No Filter & welded WG)
- Straight through to Cherry Bomb
- 2 X Slim line fans
- Chavtastic sub woofer, amp, 6x9's etc
- 266 Brakes
Stored parts:
- Cone Air Filter x 2
- Xantia 2.25" black plastic & rubber piping
- 40mm lowering springs
- Throttle cable kit
- Lucas pump setup
- Bosch setup
- Manual boost controller
- EGR Blanking plate (Mark_Airey special)
- T2
Wanted parts:
- Bigger cone filter / BMC CDA
- Custom intake piping
Future plans are to get some bigger brakes on, get the FMIC plumbed in, turn the boost up to 24~30 PSI (along with increasing the fuel obviously) and possibly if funds permit pay someone to weld a bigger turbo on.
Heres an old picture, I need to get some new ones soon:
The beast of a FMIC that arrived today (what have I done lol)!?
Can fits in the inlet/oulet:
Comparison against a beer:
Comparison against a 32" TV:
Any comments good or bad welcomed.