26-06-2016, 07:04 PM
I've been testing the Holset. As suspected it's vanes are controlled by a boost actuator so no faffing about with swapping from a vac actuator.
The standard bike pump worked and compared to the GT23V I had on the XUD11 it starts moving a few psi later and finishes a little later at 30psi.
Not in the video but I was spinning the blades by turning the nut on the end of the shaft by hand and even at that slow speed you can feel it blowing air! It's gonna be a beast.
https://youtu.be/5Hz84VtKPZM
The standard bike pump worked and compared to the GT23V I had on the XUD11 it starts moving a few psi later and finishes a little later at 30psi.
Not in the video but I was spinning the blades by turning the nut on the end of the shaft by hand and even at that slow speed you can feel it blowing air! It's gonna be a beast.
https://youtu.be/5Hz84VtKPZM