03-01-2015, 11:58 AM
Hi!
My passenger electric window is fixing me I think. It will wind down but not up.
I know it's not the motor cos I used a cordless drill battery to apply power both ways and it winds up and down, (that's how I got the bugger shut again!)
I've checked the switch and ordered another second hand one, still
Same prob. I have used multimeter to check power at switch (on the wires going into back of connector). Although I'm not entirely sure I did it right. I put black multimeter lead on the earth wire in plug, and then red one on wires 608 and 609 (beige and red respectively) as these appeared to be the wires going to motor according to haynes wiring diagram. Both 608 and 609 showed power when I toggled the switch. Does this mean the switch is ok and there is a wiring prob somewhere else?
Also, how do I get the rubber boot/conduit thingy off in order to check there are no damaged wires where the flex between door and body?
Thanks
J
My passenger electric window is fixing me I think. It will wind down but not up.
I know it's not the motor cos I used a cordless drill battery to apply power both ways and it winds up and down, (that's how I got the bugger shut again!)
I've checked the switch and ordered another second hand one, still
Same prob. I have used multimeter to check power at switch (on the wires going into back of connector). Although I'm not entirely sure I did it right. I put black multimeter lead on the earth wire in plug, and then red one on wires 608 and 609 (beige and red respectively) as these appeared to be the wires going to motor according to haynes wiring diagram. Both 608 and 609 showed power when I toggled the switch. Does this mean the switch is ok and there is a wiring prob somewhere else?
Also, how do I get the rubber boot/conduit thingy off in order to check there are no damaged wires where the flex between door and body?
Thanks
J