A Street Sleeper is reborn! THE END

[procta]

Does it need a code buddy? Also, can I talk you into putting Superlites on this? That would look so amazing, although it would detract from the sleeper angle....

yeah it will do sadly from what the last owner said. I can have a check of the paper work, but who is to say this is the original radio, as I found that some one has been at the doors speaker wise.

if you want to do some digging wise in radio code by pass, then go for it. I have the radio here for you!

---

right today while it was pissing down with rain on and off, I decided to finish off round one, I need to swop over the boot lid wiring from my gta, to make the boot light work, but that will happen when I swop the locks over, as that's the next step now and glass.

so this is where I left off last night.


so continued from there, and made sure all was right with the world.

fuse box was installed


then the dash was put back on the car,


I then moved on to the rear of the car, and I had a bit of a f*ck on as the panels on this car are rived on, and I wasn't keen on drilling, as I don't think we have the drill bits.
so no photos of that, ( nothing really to see there)

then I switched back to the front of the car and fitted back the steering wheel and a few odds and sods.






the gta clocks with rev counter ( as that has the more miles an hour on and a worthly upgrade away)


the old one that will be gutted for its bulbs



the radio blank back in place and I need to see if I have choke blank grommet for the choke system, also I am going to place the hazard switch on my console on the gauges or put it on the cowling.



I did a test and all works spot on! I need to change a few things over for the door wise but we practically have a working car again!

---

still got a few things to do, but I think its a case of gutting the gta of everything now, as I want to swop the locks and glass over, and make a start on pre vvc stuff.