07-01-2012, 06:19 PM
Spent today building up a new head for it, engines original head sadly has trashed bearings / cams due to poor previous oil maintenance, so decided it was pretty much only good for spares, but managed to get a fair bit of money back from the seller, so bought another bare cast and build it back up today, haven't been able to finish as im still waiting on some seals, and a new chain / tensioner kit to turn up, but got it all cleaned up / ready to finish putting back together anyway.
Infact not sure if ive mentioned it before, but yes, its a valver mtdi!
![[Image: 1.jpg]](http://i281.photobucket.com/albums/kk226/darrenjlobb/1.jpg)
![[Image: 2.jpg]](http://i281.photobucket.com/albums/kk226/darrenjlobb/2.jpg)
![[Image: 3.jpg]](http://i281.photobucket.com/albums/kk226/darrenjlobb/3.jpg)
![[Image: 4.jpg]](http://i281.photobucket.com/albums/kk226/darrenjlobb/4.jpg)
Still hoping to get block to machinist for machining next week time allowing!
Darren
Infact not sure if ive mentioned it before, but yes, its a valver mtdi!
Still hoping to get block to machinist for machining next week time allowing!
Darren
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia |
![[Image: sigi-2.png]](http://i281.photobucket.com/albums/kk226/darrenjlobb/sigi-2.png)
| #DervMafia |