TD04 Clearnace

[Dan!]

Aye, K03 and GT15 share the same mani

[Harky]

Checked mine the other day and it ain't hitting the bulkhead so yeap, possible with no bashing!

Think one of my rattles was one of the pipes going to the mbc, was sitting up against the brake servo in a funny kinda way. Other noise's just coming from the exhaust leaking, going to pull it off tonight and try and seal it up again...then ready to start trying to get some decent boost!

[studturbo]

Witch one of theses mani would be better for my TD04 as i got it today t2 mani or a kkk mani ?

[mark_airey]

Witch one of theses mani would be better for my TD04 as i got it today t2 mani or a kkk mani ?

The T2 and K14 use the same manifold..............the gt15 uses the other design which allows the turbo to sit slightly lower

[studturbo]

I aint got a gt15 manifold what thay like on the t2 manifold ?

[ash23]

no waste gate on a t2/k14 mani

[studturbo]

I could if i mount waste gate under neaf it tho couldnt i ?
look at this http://www.theywhoshallnotbenamed/forum/showthread. ... light=td04

[mark_airey]

I could if i mount waste gate under neaf it tho couldnt i ?
look at this http://www.theywhoshallnotbenamed/forum/showthread. ... light=td04

Nope, there isn't room for the actuator in any position which will allow you to reach the wastegate arm! Just weld it closed and stop messing about :p

[studturbo]

Weld it shut lol

[ash23]

or use the k03/gt15 manifold and have proper control over your boost

[studturbo]

where would i get a k03/gt15 one from cos am not buying full turbo lol

[ash23]

i would assume the scrappers / ebay will have one

[studturbo]

Ill try ebay and my m8s just scraped a 306 with a gt15 on aswell gutted

[ash23]

there is one on egay but he ants £35 for it lol scrappy near me only charged me £7 lol

[mark_airey]

Weld it shut lol

Yes, weld it shut..................

[studturbo]

Where you from ash ? think ill have too have a drive down lol