Nope...
Thats me gutting a 2.5bar (1.5bar max boost) map sensor and fitting a MPX6400 thus making a 4bar (3bar max boost) map sensor
Put the FET for the N75 as close to N75 as possible. Not on the shield. I need to tidy my loom up but mine is basically dangling in the engine bay by the N75 screwed to a heatsink.
Did some more to the fine tuning today. Got it sweeping bang on but struggling with map sensor readings...hence me ripping apart the renault MAP sensor and fitting the MPX6400 chip. Resin is curing. Tomorrow we begin again!
Thats me gutting a 2.5bar (1.5bar max boost) map sensor and fitting a MPX6400 thus making a 4bar (3bar max boost) map sensor
(09-10-2014, 08:48 PM)akuma406 Wrote: Good news partner finally eliminated the signal noise. . .
So what were the problems and how do I fix it?
Put the FET for the N75 as close to N75 as possible. Not on the shield. I need to tidy my loom up but mine is basically dangling in the engine bay by the N75 screwed to a heatsink.
Did some more to the fine tuning today. Got it sweeping bang on but struggling with map sensor readings...hence me ripping apart the renault MAP sensor and fitting the MPX6400 chip. Resin is curing. Tomorrow we begin again!
Wishes for more power...