30-08-2013, 07:22 PM
Despite it being 2weeks since op I got a few bits done again today.
busy tomorrow with a gig so it was last chance before lads over sunday....
its all looking good.
got r/n/s arch liner out, arch stone chipped and undersealed and liner in after a good clean.
o/s driveshaft out...correct shaft seal put in and all back together
turbo exhaust from mani bolted in.
turbo bolted all in place with oil drain pipe finished. turbo exhaust downpipe done.
tall 2.1 fuel filtet housing modded and sealed/bolted on.
gti m/c fitted. res' yet to go on...left off for access to bulkhead.
matrix pipes sliced and fitted.
inlet manifold cut and drilled for boost take off bits. its very tight!!...painted and drying.
rear calipers prepped for painting.
things extra found to do....bottom engine mount fork is a tu one...I need a xud one.. which I have...must have muddled them up!
looking good for sunday!
busy tomorrow with a gig so it was last chance before lads over sunday....
its all looking good.
got r/n/s arch liner out, arch stone chipped and undersealed and liner in after a good clean.
o/s driveshaft out...correct shaft seal put in and all back together
turbo exhaust from mani bolted in.
turbo bolted all in place with oil drain pipe finished. turbo exhaust downpipe done.
tall 2.1 fuel filtet housing modded and sealed/bolted on.
gti m/c fitted. res' yet to go on...left off for access to bulkhead.
matrix pipes sliced and fitted.
inlet manifold cut and drilled for boost take off bits. its very tight!!...painted and drying.
rear calipers prepped for painting.
things extra found to do....bottom engine mount fork is a tu one...I need a xud one.. which I have...must have muddled them up!
looking good for sunday!
Wishes for more power...