04-12-2011, 09:41 PM
Right, well done a load of the shit jobs that needed doing before MOT...
New wheel bearings - bitch of a job, but got it done...
Hub off...
Circlips are a shit to get out...
Darren loves using the hydraulic press!!!
Bearing out...
Fed _the_ cutest/friendliest lambs in the world...
The lobbland turbo pile...
Then set about the rear brakes - which were a bit dicked...
Pads too...
In pieces.. Shiny discs...
Ooooh Shiny!
Fisted Darren's turbo...
Got really irritated by the front brake lines whilst fitting the new braided lines - wouldnt undo, then flaring was a failure etc... Finally got it done - ignore the sea of oil down the back, gotta love rocker cover gasket leaks, when the bearing caps threads are sheared...
Ooooh Shiny!
And now done... Just the exhaust and a detune and then give the car the once over and we should be ready for MOT!
New wheel bearings - bitch of a job, but got it done...
Hub off...
Circlips are a shit to get out...
Darren loves using the hydraulic press!!!
Bearing out...
Fed _the_ cutest/friendliest lambs in the world...
The lobbland turbo pile...
Then set about the rear brakes - which were a bit dicked...
Pads too...
In pieces.. Shiny discs...
Ooooh Shiny!
Fisted Darren's turbo...
Got really irritated by the front brake lines whilst fitting the new braided lines - wouldnt undo, then flaring was a failure etc... Finally got it done - ignore the sea of oil down the back, gotta love rocker cover gasket leaks, when the bearing caps threads are sheared...
Ooooh Shiny!
And now done... Just the exhaust and a detune and then give the car the once over and we should be ready for MOT!