Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Front wheel bearings
#10
The strut should come out of the hub without needing to remove that bolt. To free up the TRE turn onto full lock (as if the front of the wheel is pointing in towards the engine bay) and hit the side of the hub casting where the TRE spigot goes through, hit it hard. Obviously undo the nut first else it won't be able to drop out lol. Spraying a bit of penetrating fluid on everything first should help too.
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



Reply
Thanks given by:


Messages In This Thread
Front wheel bearings - by mackat - 01-09-2015, 09:09 PM
RE: Front wheel bearings - by Poodle - 02-09-2015, 05:22 AM
RE: Front wheel bearings - by mackat - 02-09-2015, 11:06 AM
RE: Front wheel bearings - by Toms306 - 02-09-2015, 11:11 AM
RE: Front wheel bearings - by mackat - 02-09-2015, 12:08 PM
RE: Front wheel bearings - by 306Dan - 02-09-2015, 06:14 PM
RE: Front wheel bearings - by Toms306 - 02-09-2015, 06:26 PM
RE: Front wheel bearings - by Poodle - 03-09-2015, 05:45 AM
RE: Front wheel bearings - by mackat - 30-09-2015, 04:25 PM
RE: Front wheel bearings - by Poodle - 01-10-2015, 06:32 AM
RE: Front wheel bearings - by mackat - 01-10-2015, 05:49 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Front wheel bearings Mighty306 0 1,624 22-08-2020, 02:03 PM
Last Post: Mighty306
  Knock from the front left wheel area johnny625 15 9,629 08-05-2019, 03:15 PM
Last Post: Zxmad98
  Front Wheel Alignment pug306driver 1 1,411 09-07-2016, 07:41 PM
Last Post: DeeTurbo

Forum Jump:


Users browsing this thread: 1 Guest(s)