Search Results
|
Post |
Author |
Forum |
Replies |
Views |
Posted
[asc]
|
|
|
Thread: Pugfest 2019 - 30/06/19
Post: RE: Pugfest 2019 - 30/06/19
Is there any space for two dirty diesel 205's on the stand? Last year I parked my green 205 STDT on the 306oc stand, was wondering if me and a friend can do the same again this year?
They both have... |
|
Farmer-Glen |
Meets
|
26 |
18,612 |
06-06-2019, 10:20 AM |
|
|
Thread: Peugeot 205 STDT
Post: RE: Peugeot 205 STDT
A quick update on my progress recently, I have sorted out my fuel pump issues...threw away the old pump and replaced it with this:
Got my clean on and gave it an ultrasonic bath and rebuild :) ... |
|
Farmer-Glen |
Projects
|
20 |
6,333 |
17-08-2015, 09:01 PM |
|
|
Thread: Peugeot 205 STDT
Post: RE: Peugeot 205 STDT
Yeah Ive done that, just seems to introduce a massive delay in the throttle if I drop it back anymore splines... |
|
Farmer-Glen |
Projects
|
20 |
6,333 |
18-06-2015, 12:24 PM |
|
|
Thread: My STDT Project...
Post: RE: My STDT Project...
Kracking fabrication and kwality paintwork there....you must have had an expert helping you.... :D |
|
Farmer-Glen |
Projects
|
6 |
1,971 |
17-06-2015, 07:38 PM |
|
|
Thread: Peugeot 205 STDT
Post: RE: Peugeot 205 STDT
The reason everyone missed it at FCS was because it wasn't there :itwasntme: I was hoping to take it but the fuel pump was in pieces on the bench on the Friday before the show so I had to drive the B... |
|
Farmer-Glen |
Projects
|
20 |
6,333 |
17-06-2015, 07:33 PM |
|
|
Thread: Peugeot 205 STDT
Post: RE: Peugeot 205 STDT
It was awesome to meet some of you guys (and girls) at the French Car Show this year :) I thought I would give you an update on the progress of my 205 STDT project!
Quite a few thigs have change ... |
|
Farmer-Glen |
Projects
|
20 |
6,333 |
15-06-2015, 08:21 PM |
|
|
Thread: Peugeot 205 STDT
Post: RE: Peugeot 205 STDT
Its not my daily driver :) so I'm not too concerned when it inevitably does throw a rod out the block! gives me an excuse to re-build another engine :D |
|
Farmer-Glen |
Projects
|
20 |
6,333 |
16-09-2014, 08:34 PM |
|
|
Thread: Peugeot 205 STDT
Post: RE: Peugeot 205 STDT
Would have liked more room! The compressor is about 10mm from the steering UJ :S |
|
Farmer-Glen |
Projects
|
20 |
6,333 |
16-09-2014, 08:29 PM |
|
|
Thread: Peugeot 205 STDT
Post: Peugeot 205 STDT
Well after a successful post in the introduction section of the forum I thought I would do a project build thread showing a bit more detail about what I have done so far :)
Bought the car back in 2... |
|
Farmer-Glen |
Projects
|
20 |
6,333 |
16-09-2014, 08:07 PM |
|
|
Thread: Bosch pump conversion problems
Post: RE: Bosch pump conversion problems
Uberderv Wrote: (16-09-2014, 08:37 AM)
--
Using Lucas injectors with a Bosch pump will result in altered timing. You can strip injectors down and clean them if you think one is sticky :)
--
Yeah I ... |
|
Farmer-Glen |
XUD Section
|
16 |
3,504 |
16-09-2014, 07:08 PM |
|
|
Thread: Bosch pump conversion problems
Post: RE: Bosch pump conversion problems
I'm beginning to think the eBay listing was lying! The guy claimed it was working when it came off a month ago and it was stored with fuel in it...apparently :dodgy:
Will probably end up putting th... |
|
Farmer-Glen |
XUD Section
|
16 |
3,504 |
15-09-2014, 07:43 PM |
|
|
Thread: Bosch pump conversion problems
Post: RE: Bosch pump conversion problems
Grrr :dodgy: car wont start at all now, just plumes out white smoke!! Swapped out the injectors for the lucas ones, it fired up for about 2 seconds and then stopped, now its not smoking at all :huh: d... |
|
Farmer-Glen |
XUD Section
|
16 |
3,504 |
15-09-2014, 07:00 PM |
|
|
Thread: Bosch pump conversion problems
Post: RE: Bosch pump conversion problems
Ok Jimbo will do :) was a bit weary at first in case it ran away but will make sure I can stall it if it does!
Looks like the injector on cylinder one is weeping slightly so that may be the source ... |
|
Farmer-Glen |
XUD Section
|
16 |
3,504 |
14-09-2014, 10:14 AM |
|
|
Thread: Bosch pump conversion problems
Post: RE: Bosch pump conversion problems
It would only be temporary to source the problem, would then get a replacement bosch if I found a faulty one :) |
|
Farmer-Glen |
XUD Section
|
16 |
3,504 |
14-09-2014, 09:28 AM |
|
|
Thread: Bosch pump conversion problems
Post: RE: Bosch pump conversion problems
Good news! Its not the dacia sandero...
I cracked off the injector lines at the injectors and turned it over for a while, there was some air in the lines I think!
It now starts :D but doesn't idle, ... |
|
Farmer-Glen |
XUD Section
|
16 |
3,504 |
14-09-2014, 09:23 AM |
|
|
Thread: Bosch pump conversion problems
Post: RE: Bosch pump conversion problems
vincent1 Wrote: (13-09-2014, 08:00 PM)
--
was you on a bosch or lucas pump before?
--
Was on a Lucas before, swapped the studs over to the other holes too... |
|
Farmer-Glen |
XUD Section
|
16 |
3,504 |
13-09-2014, 09:03 PM |
|
|
Thread: Bosch pump conversion problems
Post: Bosch pump conversion problems
Just fitted a bosch pump with 11mm conversion (purchased off ebay, in working condition) onto my 205.
The engine is a 1.8 XUD7, I have changed the pump, injectors and injector lines but I cant get ... |
|
Farmer-Glen |
XUD Section
|
16 |
3,504 |
13-09-2014, 05:57 PM |
|
|
Thread: A brief introduction
Post: RE: A brief introduction
Toms306 Wrote: (13-09-2014, 08:20 AM)
--
Looks good!
I'm not sure on the fibre glass exhaust though, would've thought it'd just melt!?
--
Thanks everyone! What I meant is the exhaust has glass f... |
|
Farmer-Glen |
Newbies
|
10 |
1,651 |
13-09-2014, 08:29 AM |
|
|
Thread: A brief introduction
Post: A brief introduction
Hi there!
Technically I don't currently own a 306 :s but have owned one in the past (D-turbo which I regret selling) and currently have a 205 which is close enough :D
So anyway i'm in the proce... |
|
Farmer-Glen |
Newbies
|
10 |
1,651 |
12-09-2014, 07:41 PM |