+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: Inlet manifold pushed up against master cylinder (/showthread.php?tid=9515)
Inlet manifold pushed up against master cylinder - Ben - 05-01-2013
I've just put the new engine in the car, using the same inlet manifold and engine mounts. I used to have a gap of a few mm between the two of them, but now the inlets pushing into the MC. So the engines moved around 5 mm to the side/up.
Really can't think why,any ideas?
RE: Inlet manifold pushed up against master cylinder - Ricky - 05-01-2013
How far along the slots is it on the gearbox mount?
RE: Inlet manifold pushed up against master cylinder - Ben - 05-01-2013
Good idea that I'd forgotten about those slots. I'll make sure its moved right over on those slots tomorrow and see if that makes the difference.
RE: Inlet manifold pushed up against master cylinder - Ricky - 05-01-2013
I know someone else who had the same problem, he moved it on the slots and has been fine since.
RE: Inlet manifold pushed up against master cylinder - Ben - 05-01-2013
Cool, hopefully will sort it out tomorrow then. Repped for the good idea!
RE: Inlet manifold pushed up against master cylinder - Ricky - 05-01-2013
RE: Inlet manifold pushed up against master cylinder - darrenjlobb - 05-01-2013
What he said ^^