+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: XUD oil feed block thread size (/showthread.php?tid=9121)
XUD oil feed block thread size - strictly_perv - 20-12-2012
Does anyone happen to know the thread size for the block off the top of their head? I'm trying to get a line sorted for the new blower.
Thanks
RE: XUD oil feed block thread size - zx_volcane - 20-12-2012
yup one sec...
m16 x1.5, i put n my project thread as I knew I'd want to know again
RE: XUD oil feed block thread size - Ruan - 21-12-2012
Be warned though, the length is odd... Best way is to use a T2 line with a compression fitting half way... Or find a banjo bolt out of a HDi as the length is the same
RE: XUD oil feed block thread size - darrenjlobb - 22-12-2012
Any banjo bolt will work using the right thread as the banjo only relies on the copper washers not the seat at the bottom, but that will work just fine
RE: XUD oil feed block thread size - swampy - 22-12-2012
I can sort a braided line to any spec you want