+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: General (https://www.306oc.co.uk/forum/forumdisplay.php?fid=6)
+--- Forum: Meets (https://www.306oc.co.uk/forum/forumdisplay.php?fid=8)
+--- Thread: Show: south west rr meet at ray west! 2nd feb (/showthread.php?tid=7843)
RE: south west rr meet at ray west! 2nd feb - sam - 01-02-2013
Sure?
RE: south west rr meet at ray west! 2nd feb - David - 01-02-2013
Just run it at low psi for abit
RE: south west rr meet at ray west! 2nd feb - sam - 01-02-2013
Standered at 24 psi cant go any lower haha
RE: south west rr meet at ray west! 2nd feb - David - 01-02-2013
Really?
RE: south west rr meet at ray west! 2nd feb - sam - 01-02-2013
Is indeed
RE: south west rr meet at ray west! 2nd feb - Ricky - 01-02-2013
Turn the fuel down then, it will probably still make full boost, but no power with it. Just take it for a nice long night drive!
RE: south west rr meet at ray west! 2nd feb - David - 01-02-2013
Got the plan of action is all sorted dude
RE: south west rr meet at ray west! 2nd feb - Anton - 01-02-2013
Ricky - 130hp dt
Sean - 160hp hdi
Sam - 150hp dt
David - 160/170hp dt
Jamie - 167hp '6
Niall - 129bhp
Chris - 165bhp '6
Ozone - 150hp dt
Frosty - 150hp S16
MIKE-FORD - 112bhp hdi
Poodle - 120bhp HDi
Kwik - 125bhp DT
Dum-Dum 175bhp and 400nm (2.2HDi)
Pipps - 160bhp and 360nm (2.0 HDi)
Anton - 115bhp ZX
RE: south west rr meet at ray west! 2nd feb - Tom - 01-02-2013
Looks like some pretty good results there!
RE: south west rr meet at ray west! 2nd feb - Toms306 - 01-02-2013
Results? Unless they've got a time machine those are predicted figures....
Done my own dyno run twice at college and this is how were told - pull away in 4th and floor the throttle, the dyno starts reading at 30mph (and feels like youve hit a puddle at that point) then keep on the throttle until you start losing bhp (or hit the limiter). Then let off the throttle to run down to calculate the tranny losses. Shouldn't damage the car at all, however, due to the extra 'strain' from the dyno over the normal road surface, you 'can' get overboost problems show up with 'quick' cars. Basically in normal driving youre on full throttle for only few seconds usually as thats all it takes to get to illegal speeds, on the dyno it takes 10+ seconds so the turbo gets more abuse than normal. I got an overboost fault doing my second run and put the car into limp mode, but apparently its not uncommon.
RE: south west rr meet at ray west! 2nd feb - tb205gti - 01-02-2013
(01-02-2013, 05:24 PM)Toms306 Wrote: you 'can' get overboost problems show up with 'quick' cars.
It all depends on the weight of the rollers and/or the brake used (if any is used). Too light rollers and you'll not get as fast turbo spool as on the road, and you'll not see the full torque.
Also measured MAF is lower when doing a powerrun on the rollers compared to when it is on the road.
The rollers I normally use have two 1t rollers - I normally get clutch slipping on it when doing a pull in 4th. I do not get any clutch slipping when on the road with slightly more diesel. (it slips @ 430Nm on the rollers)
(01-02-2013, 05:24 PM)Toms306 Wrote: Basically in normal driving youre on full throttle for only few seconds usually as thats all it takes to get to illegal speeds, on the dyno it takes 10+ seconds so the turbo gets more abuse than normal. I got an overboost fault doing my second run and put the car into limp mode, but apparently its not uncommon.
A powerrun should not be shorter than ~18 seconds -if it is, then the possibility of getting a duff reading is substantially higher.
RE: south west rr meet at ray west! 2nd feb - Ricky - 01-02-2013
Where's the meeting place then?
RE: south west rr meet at ray west! 2nd feb - ozonehostile - 01-02-2013
i plan to be on well on the way there by 11, mates got to mot his new car at 10, so il wait around to see if it passes then hopefully have a mini convoy down.
i havnt decided which route yet, what road will most people travelling from north be using? motorway or birdlip?
whats the postcode for the meeting place, cant be bothered to trawl through previous pages to look
RE: south west rr meet at ray west! 2nd feb - sam - 01-02-2013
Just meet at ray west guys, didnt realise people will be turning up at different times
RE: south west rr meet at ray west! 2nd feb - Ricky - 01-02-2013
What time you getting there Sam?
RE: south west rr meet at ray west! 2nd feb - Frosty - 01-02-2013
Hopefully going to get there about 9 but its looking like i will have to leave about 11.30/12
RE: south west rr meet at ray west! 2nd feb - sam - 01-02-2013
(01-02-2013, 10:03 PM)Ricky Wrote: What time you getting there Sam?
I have to be there buy 8:30 dude
(01-02-2013, 11:24 PM)Frosty Wrote: Hopefully going to get there about 9 but its looking like i will have to leave about 11.30/12
Ill be there at that time dude, shame about the leaving time dude
Well ill see you all in the morning
RE: south west rr meet at ray west! 2nd feb - David - 01-02-2013
And he will be driving!
RE: south west rr meet at ray west! 2nd feb - Poodle - 02-02-2013
I need an 18mm nsf hub assembly, anyone got one they can bring?
RE: south west rr meet at ray west! 2nd feb - Just Sean - 02-02-2013
(01-02-2013, 11:46 PM)David Wrote: And he will be driving!
Lol! Fingers crossed!
RE: south west rr meet at ray west! 2nd feb - David - 02-02-2013
I put it all back together and the turbo has been primed ready for an early start tomorrow
RE: south west rr meet at ray west! 2nd feb - MIKE-FORD - 02-02-2013
ill be there around 9 people
RE: south west rr meet at ray west! 2nd feb - Just Sean - 02-02-2013
(02-02-2013, 01:40 AM)David Wrote: I put it all back together and the turbo has been primed ready for an early start tomorrow
Awesome! good work guys! you was right in the shit when we came down!
RE: south west rr meet at ray west! 2nd feb - David - 02-02-2013
Oh don't get me started lol I was getting so so pissed off with it. After you left the pipe inbetween the head and the inlet came out and I had to drop then engine again!
RE: south west rr meet at ray west! 2nd feb - sam - 02-02-2013
David got lemon really bad
RE: south west rr meet at ray west! 2nd feb - Kwik - 02-02-2013
I'm here and is a pain to find. Follow signs to race circuit as you go past the karting centre and see. The thruxton race circuit entrance you will see a hanger between them. Is there where it says G.A.S. Vehicle services just underneath that says west tuning
RE: south west rr meet at ray west! 2nd feb - sam - 02-02-2013
Me and david are on our way now
but in one car mine is being a f*** and not starting
RE: south west rr meet at ray west! 2nd feb - ozonehostile - 02-02-2013
(02-02-2013, 08:23 AM)sam Wrote: Me and david are on our way now
about your caril be on my way in the next hour, hope to be with you all before 12
RE: south west rr meet at ray west! 2nd feb - Jonny81191 - 02-02-2013
Should be able to get there for 12. Looking forward to this
RE: south west rr meet at ray west! 2nd feb - ozonehostile - 02-02-2013
(02-02-2013, 08:46 AM)Jonny81191 Wrote: Should be able to get there for 12. Looking forward to this
which way are you heading there johnny?