306oc - Peugeot 306 Owners Club & Forum
1.6 fps wiring - Printable Version

+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: DW10 HDi section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=10)
+--- Thread: 1.6 fps wiring (/showthread.php?tid=36954)

1.6 fps wiring - dr_jekyll - 04-07-2018

Cant remember which two wires require being swapped for the 1.6 fps to work. Anyone recall as cant find the original post and old looms been scrapped.

Also after where the power leads go for the starter. Believe it goes battery>starter>alternator but its been so long since i removed it i cant remember [Image: c2cb582d8ab18b8bc7524f9b24631a2a.jpg]

Sent from my BLA-L09 using Tapatalk

RE: 1.6 fps wiring - Dave - 05-07-2018

Saw this thread and could not help but think of Counter-Strike.

Sorry I know thats absolutely no help whatsoever.

RE: 1.6 fps wiring - Poodle - 06-07-2018

Battery-starter-alternator is correct. Can't remember which wires need to be swapped on the frps, sorry.

RE: 1.6 fps wiring - dr_jekyll - 06-07-2018

(06-07-2018, 06:30 PM)Poodle Wrote: Battery-starter-alternator is correct. Can't remember which wires need to be swapped on the frps, sorry.
Thank you!

Sent from my BLA-L09 using Tapatalk

RE: 1.6 fps wiring - Uberderv - 22-07-2018

Never swapped the sensor over but I believe it's wires 1 + 2 need swapping. I think wire 3 is +5v.

RE: 1.6 fps wiring - dr_jekyll - 25-07-2018

(22-07-2018, 10:58 AM)Uberderv Wrote: Never swapped the sensor over but I believe it's wires 1 + 2 need swapping. I think wire 3 is +5v.
Am i right in thinking that the wires needed swapping then for the 1800 bar fps swear i read it somewhere ages ago

Sent from my BLA-L09 using Tapatalk

RE: 1.6 fps wiring - Ruan - 25-07-2018

Yes that's right - if you're using a 1920.GW from a 1.6HDi you need to swap wires, the pinout is different.

Can't remember which wires need swapping though.

EDIT: Because I'm really good to you, just went and found diagrams -

1.6HDi
1 - Ground
2 - Signal
3 - +5v

2.0 8v HDi
1 - Signal
2 - Ground
3 - +5v

So in answer, yes, 1 & 2 need swapping.