+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: Egt Limit for Gtb2062vklr? (/showthread.php?tid=36940)
Egt Limit for Gtb2062vklr? - Biggen - 23-06-2018
Hi Friends.
What can a gtb2062vklr allow concerning the maximum egt on a Xud11T? For safe uses.
Thanks
RE: Egt Limit for Gtb2062vklr? - Piggy - 25-06-2018
I didn't even know they made a gtb2062vklr to be honest.
Ask garret be your best bet
RE: Egt Limit for Gtb2062vklr? - Biggen - 25-06-2018
Hi Piggy
In fact, it's a GTB2060VKLR with a MFS 62MM
I changed the angle of the outlet compressor
For the fitting of the KN filter, i made an adaptator
RE: Egt Limit for Gtb2062vklr? - Dave - 26-06-2018
Beauty,
As with all VNT's, upto 800 should be fine.
I have seen 1000+ many times with no issues for short bursts, but 800 seems safe for long hauls.
1300 is when stuff can go real wobbly and you want to see the death of your blower.
All subject to opinion based on different peoples experiences
RE: Egt Limit for Gtb2062vklr? - Biggen - 26-06-2018
Thanks Dave.
First test with 1.4Bar and 9mm headpump. I reached to 690deg.
I think with the next 11mm it will increase fastly....
But i gonna check frequently....
This turbo is wonderful!!!
RE: Egt Limit for Gtb2062vklr? - bashbarnard - 27-06-2018
I used to see about 800 on a sustained pull with 11mm gt2052s blowing clean no smoke. I could get it higher and did a few times. I had to fettle it a fair bit though. First setup of the 11mm I was seeing 900+ a few times before I got round to changing anything. Seems to have lived on fine though.
RE: Egt Limit for Gtb2062vklr? - Biggen - 27-06-2018
Ok. Eager to fit my futur 11mm pump