![]() |
Why is it not flaming? - Printable Version +- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum) +-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16) +--- Forum: XU Petrol Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=17) +--- Thread: Why is it not flaming? (/showthread.php?tid=33453) |
Why is it not flaming? - Matt - 08-03-2016 right so the Rallye has a decat (cut open and emptied cat) straight through to hollow box My mates expect flames, I had a straight thorough before and it did it, so it worries me that it's not. Is it running to lean or something. I'm too tired to work it out haha RE: Why is it not flaming? - Piggy - 09-03-2016 (08-03-2016, 11:00 PM)Matt Wrote: I'm too high to work it out haha EFA ![]() RE: Why is it not flaming? - cully - 09-03-2016 maybe the magic dragon has lost its Puff? RE: Why is it not flaming? - Eeyore - 09-03-2016 Maybe the car has decided not to f*ck itself over spitting flames... RE: Why is it not flaming? - Matt - 09-03-2016 I'm never high ![]() So the fact it doesn't flame is normal? Someone mentioned to me the car could be running lean and that's why, which last night made perfect sense as I was so tired. But now not so sure. If it's not meant to do it then I guess that's fine, I have a healthy engine after all ![]() RE: Why is it not flaming? - Eeyore - 09-03-2016 So... Mine has a magnex decat and a full brand new piper stainless system. It doesn't pop yet alone flame. RE: Why is it not flaming? - silverzx - 09-03-2016 Try making spark plug gap bigger. RE: Why is it not flaming? - welshpug - 09-03-2016 (09-03-2016, 12:05 PM)silverzx Wrote: Try making spark plug gap bigger. surefire way to kill an engine that, as the electrode falls off and pings around the chamber, stopping a spark and allowing a ton of fuel to hit a hot exhaust, you'll have lots of flame then ![]() RE: Why is it not flaming? - silverzx - 09-03-2016 (09-03-2016, 12:12 PM)welshpug Wrote:(09-03-2016, 12:05 PM)silverzx Wrote: Try making spark plug gap bigger. He didn't say I wasn't allowed to kill the engine... He wanted flames... I gave the man flames... ![]() RE: Why is it not flaming? - Midnightclub - 09-03-2016 If you take it up to nearly the limiter in say 3rd, then dab the throttle on/off as the revs are dropping does it flame then? RE: Why is it not flaming? - Toms306 - 09-03-2016 Just run a fuel line down to the exhaust... ![]() RE: Why is it not flaming? - Stef205 - 09-03-2016 can of petrol and a match, and no you cant fit a omex rev limiter to it! RE: Why is it not flaming? - Jonny81191 - 09-03-2016 just flick the ignition on the overrun.. RE: Why is it not flaming? - cully - 09-03-2016 (09-03-2016, 06:34 PM)Jonny81191 Wrote: just flick the ignition on the overrun.. you been taking lessons from the two stroke boys RE: Why is it not flaming? - Jonny81191 - 09-03-2016 (09-03-2016, 06:53 PM)cully Wrote:(09-03-2016, 06:34 PM)Jonny81191 Wrote: just flick the ignition on the overrun.. it works though ![]() RE: Why is it not flaming? - 7057sam - 09-03-2016 What size is it my magnex is 2.5 and makes like a gay fart and my mate 2.25 proper bangs. Also check everywhere for airleaks a some one of them and bye bye to bang bang. RE: Why is it not flaming? - Matt - 09-03-2016 Haha I'm not after flames, just wondered why it didn't ![]() RE: Why is it not flaming? - ginge191 - 09-03-2016 Can I try make it flame? RE: Why is it not flaming? - Ruan - 11-03-2016 Normally never flame/bang/fart unless provoked by cracking the throttle at around 4-6k RPM on the overrun. The management is calibrated well enough that it doesn't really do that, sometimes you'll get a very slight whiff of flame/black smoke when lifting off at high RPM, but usually not. If it did before, it's likely it had an air leak on the inlet side causing it. RE: Why is it not flaming? - Matt - 12-03-2016 Thinking about it, it was my old engine that would do it. The f*cked one haha Think that did have an air leak somewhere aswell now I think about it. I'm not fussed about having the flames etc just wondered why it was so different even though I am straight through RE: Why is it not flaming? - Ruan - 12-03-2016 I'll bet if you crack the throttle between 6-4 on the overrun after nailing it, it'll bang and fart. RE: Why is it not flaming? - Matt - 14-03-2016 It bangs it tits off now. There was a blow in the exhaust. Now I need to try and stop in popping and burbling on overrun haha RE: Why is it not flaming? - spillage - 14-05-2017 (09-03-2016, 07:25 AM)Piggy Wrote:(08-03-2016, 11:00 PM)Matt Wrote: I'm too high to work it out haha Lol |