Relocation Mani Query - Printable Version +- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum) +-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16) +--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11) +--- Thread: Relocation Mani Query (/showthread.php?tid=30125) |
Relocation Mani Query - silverzx - 17-04-2015 People going above or below this? I'm gonna try go over, then there is plenty of space for exhaust to run back down? RE: Relocation Mani Query - Dum-Dum - 17-04-2015 Maybe grind off the flange and weld a 90* bend to the water pipe? RE: Relocation Mani Query - silverzx - 17-04-2015 (17-04-2015, 12:39 PM)Dum-Dum Wrote: Maybe grind off the flange and weld a 90* bend to the water pipe? Or grind it back an inch or two, put an inch of pipe on, with a hard 90 coming out. People going above or below this is the question at hand though. RE: Relocation Mani Query - Paul Baldwin - 02-05-2015 I've gone below on the ones I've done for Tom mate. Just keep it tight to the block and there is room for a 3" turbo exit pipe, on a ZX anyway :-) Dum Dums idea is easy enough tho, that water pipe is weldable but it's thin and rusty. RE: Relocation Mani Query - Lolben91 - 02-05-2015 I went under, but then found the gear links made contact, its quite a tight bit of space there |