+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: bonnet liner (/showthread.php?tid=23677)
bonnet liner - daveylennon93 - 30-04-2014
Does the scoop in the bonnet liner actually channel air to the IC? IS THERE any way to modefy it to make it better?
RE: bonnet liner - DarkInferno - 30-04-2014
I did test it at one point, and it was actually pretty efficient.
I'm sure somebody will be along shortly with another opinion.
RE: bonnet liner - daveylennon93 - 30-04-2014
Yeah thought that. Mine was hangin down so I pulled it off. Only afted realised that it channelled air up to I.c. If you could get a bigger opening in it or extend it down closer to the front id say it would be lots efficient?
RE: bonnet liner - welshpug - 30-04-2014
I doubt quite highly that you will improve on it, when the car is moving there's a decent amount of air pressure un the fan cowling area that any air not going through the rad will go up through the intercooler.
RE: bonnet liner - daveylennon93 - 30-04-2014
So should i definatly try and pin bak up the liner or just leave it off is what im wonderin?
RE: bonnet liner - welshpug - 30-04-2014
I would fit it, get new clips.
RE: bonnet liner - daveylennon93 - 30-04-2014
Sound thanks.
RE: bonnet liner - Owen_G_ - 01-05-2014
I'd leave it on for the sake of it. FMIC really is the best way to get cool air imo.
RE: bonnet liner - Kwik - 02-05-2014
Get a wire coat hanger make it rectangle and put it in to hold the front of the opening open. A Genuine Original Kwik bodge that helps loads lol.
RE: bonnet liner - daveylennon93 - 02-05-2014
Yeah mite do that because its pretty squashed lookin.
Just drilled holes and cable tied it up. Not arsed gettin clips