Driveshaft Intermediate Bearing Problem - Printable Version +- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum) +-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16) +--- Forum: DW10 HDi section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=10) +--- Thread: Driveshaft Intermediate Bearing Problem (/showthread.php?tid=23336) |
Driveshaft Intermediate Bearing Problem - Toms306 - 18-04-2014 Hello, Not really sure whats happened here...basically the long shaft is sitting out of the box a bit, its meched with the diff and drives fine, but is leaking 'box oil. Now when I refitted the shaft, the bearing wouldn't go fully in, the nuts got really tight while it was still about 5mm out, so I left it. I can't work out why it wouldn't go all the way in? And will it be alright to leave as it is? You can drive fine with the oil below the shaft level anyway lol. Managed a complete engine change and this is the part I f*ck up! Cheers Tom RE: Driveshaft Intermediate Bearing Problem - Poodle - 18-04-2014 Knock it back out with a big old socket and go over the mating faces with emery cloth, could be something stuck in there. RE: Driveshaft Intermediate Bearing Problem - Toms306 - 18-04-2014 Knock it out with a socket? My sockets don't have driveshaft slots cut into them. Really don't want to take it back out if I can help it though. RE: Driveshaft Intermediate Bearing Problem - Poodle - 18-04-2014 Hence old socket, cut a hole lol. RE: Driveshaft Intermediate Bearing Problem - Jonny81191 - 19-04-2014 it needs sorting though, take it out and try again.. RE: Driveshaft Intermediate Bearing Problem - Toms306 - 19-04-2014 Oh I see haha. And you're right jonny, popping and refitting the bjs was a complete ass for some reason though, never had any so tight! Is there another way to do it? Maybe take the whole wishbone from subframe? Much easier to remove and refit that! RE: Driveshaft Intermediate Bearing Problem - HDi--Power - 19-04-2014 Its called manthefuckup RE: Driveshaft Intermediate Bearing Problem - Toms306 - 19-04-2014 Fail. Never assume things... Turns out its not even that side leaking, its a failed seal on the short shaft side! I overestimated the amount the bearing was out, its only about 2mm back from flush so is fine. Will be staying like it anyway. |