+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: Removing Engine from DTurbo (/showthread.php?tid=22194)
Removing Engine from DTurbo - silverzx - 15-03-2014
Whats the crack then.
Easier to drop out or use a chain/rope and a tractor?
If I was to take it out the top with a tractor I'd have to:
- Remove drive shafts
- Undo lower mount
- Disconnect loom at chassis leg (near gearbox)
- Disconnect heater matrix pipes, clutch cable, tacho sensor
- Disconnect exhaust downpipe
- Undo top mount & gearbox mount
- Lift her out
Anything else I'm missing? Does the slam panel / bumper / radiator have to come out to get enough rotation to lift it out?
Cheersssssss!
RE: Removing Engine from DTurbo - Tom - 15-03-2014
Fuel lines... And i find the easiest way is to remove the rad slam panel bumper headlights then lift it off the top mount and swing it out the front then down out the gearbox mount and your clear. And just for reference it took me 3 hours on my own first time i done it...
RE: Removing Engine from DTurbo - spike2002 - 15-03-2014
Gear linkages and pas pipe