+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: xud box stuck on release bearing (/showthread.php?tid=20136)
xud box stuck on release bearing - pugtk - 05-01-2014
I've an engine on the ground and the box is stuck on the release bearing, all bolts are loose any ideas on how to get it unstuck?
RE: xud box stuck on release bearing - mikey b - 05-01-2014
You need to remove the clutch arm if the shaft so it can turn as the thrust bearing is attached to the clutch
RE: xud box stuck on release bearing - pugtk - 05-01-2014
does the pin on the arm push out or pull out?
RE: xud box stuck on release bearing - welshpug - 05-01-2014
pull, you'll never push it out due to the casing...
if all else fails, just bend the arm.
RE: xud box stuck on release bearing - Seb_Ryan - 05-01-2014
Or if your putting a new clutch on wedge a bar inbetween box n block and force it off lol