306oc - Peugeot 306 Owners Club & Forum
Spoiler fitting - Printable Version

+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: 306 Repairs & Mods (https://www.306oc.co.uk/forum/forumdisplay.php?fid=22)
+--- Forum: Interior, Exterior, ICE (https://www.306oc.co.uk/forum/forumdisplay.php?fid=12)
+--- Thread: Spoiler fitting (/showthread.php?tid=15535)



Spoiler fitting - kentiiboii - 14-07-2013

Whats best stuff to use to fit spoiler to car?


RE: Spoiler fitting - Piggy - 14-07-2013

if its a bolt on one...nuts!


Re: Spoiler fitting - kentiiboii - 14-07-2013

No its not bolt its phase 3


RE: Spoiler fitting - puglove - 14-07-2013

tigerseal


RE: Spoiler fitting - kingy - 14-07-2013

This ^^


RE: Spoiler fitting - Piggy - 14-07-2013

weird...I got a ph3 one with bolts?!


Re: Spoiler fitting - rocker8742 - 14-07-2013

The 2 screws it comes with?


Re: Spoiler fitting - kentiiboii - 14-07-2013

It didnt come with bolts


Re: Spoiler fitting - rocker8742 - 14-07-2013

If its got screw holes and your boots got the holes you can get the screws from pug for about a quid each iirc


RE: Spoiler fitting - titch - 15-07-2013

I just bolted mine on, it came with the screws, but as said above there are pretty cheap from pug. I just put a blob of grease on the holes offered up the spoiler to the car, and then took the spoiler off and the grease left a mark where the holes needed to go, drilled the holes in the boot lid , and job done.


RE: Spoiler fitting - Grant - 15-07-2013

It all depends if you have the holes in the glass as to if you can bolt it on. Tiger seal would be a better bet than drilling glass if you don't have the holes IMO.


RE: Spoiler fitting - Piggy - 15-07-2013

you dont need to drill the glass! lmao


RE: Spoiler fitting - titch - 16-07-2013

As above if it is a phase 3 one as the OP says then you drill the bootlid, iirc it is the earlier phase ones that go through the glass.


Re: RE: Spoiler fitting - kentiiboii - 16-07-2013

(16-07-2013, 08:04 PM)titch Wrote: As above if it is a phase 3 one as the OP says then you drill the bootlid, iirc it is the earlier phase ones that go through the glass.

Correct. But I dont like idea of drilking through my boot. So tigerseal arraived today