+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: General (https://www.306oc.co.uk/forum/forumdisplay.php?fid=6)
+--- Forum: The Couch (https://www.306oc.co.uk/forum/forumdisplay.php?fid=7)
+--- Thread: New desk chair (/showthread.php?tid=1391)
New desk chair - Grant - 08-02-2012
My birds dad just finished welding this for me...
Handy knowing someone with a welder lol
![[Image: 15z5y0z.jpg]](http://i39.tinypic.com/15z5y0z.jpg)
Its incredibly comfortable, even more so than in the car lol
Re: New desk chair - Dum-Dum - 08-02-2012
Seen a few of these about mate.
Re: New desk chair - Grant - 08-02-2012
I know its not the first, but its the first one infront of my desk lol
Re: New desk chair - Scott - 08-02-2012
I want one! Donation to the 306oc office/backup server room?
Re: New desk chair - Connor - 08-02-2012
I say we make some out of foobys red flecks
Re: New desk chair - Scott - 08-02-2012
hock::think:
Re: New desk chair - 1616six - 08-02-2012
I've considered doing this in the past, but I honestly dont think i could have an office chair without arms on it!
Re: New desk chair - Niall - 09-02-2012
f*ck me it only took what? 6 months??
Re: New desk chair - mark_airey - 09-02-2012
I'm doing this, there is a leaf pattern half leather seat sat next to a buggered office chair in my workshop
I'll get around to it, pic of underneath so I can see how you have done it please (although I think I know how)
Re: New desk chair - Midnightclub - 09-02-2012
If i made one i'd keep the air bags in the seats and wire it up to a button.. defense mechanism FTW!
Re: New desk chair - darrenjlobb - 09-02-2012
Heh ive made a few of these,
Mark, just weld to bars across the runners the right width apart to take whatever base, then bolt the base on
If you do that, then you can still slide it on the runners to get the point of balance correct
Re: New desk chair - mark_airey - 09-02-2012
darrenjlobb Wrote:Heh ive made a few of these,
Mark, just weld to bars across the runners the right width apart to take whatever base, then bolt the base on
If you do that, then you can still slide it on the runners to get the point of balance correct
Yeah thats what I was planning, or removing the runners and direct bolting but I like your thinking with leaving the runners on
Welder at the ready tonight I think...........
Re: New desk chair - Strikeforce - 09-02-2012
I want one lol
Re: New desk chair - Fooby - 09-02-2012
Connor Wrote:I say we make some out of foobys red flecks
FECK
OFF
Re: New desk chair - HDIkyle - 09-02-2012
Needs the seatbelt rigging up also for use with racing games
D
Re: New desk chair - Connor - 09-02-2012
Fooby Wrote:Connor Wrote:I say we make some out of foobys red flecks
FECK
OFF
Trollolololol