+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: 306 Repairs & Mods (https://www.306oc.co.uk/forum/forumdisplay.php?fid=22)
+--- Forum: Interior, Exterior, ICE (https://www.306oc.co.uk/forum/forumdisplay.php?fid=12)
+--- Thread: Wheel Offset Question. (/showthread.php?tid=12984)
Wheel Offset Question. - ConorTRG - 17-04-2013
Im looking at a set of wheels here that are et38, what width of spacer would I need to fit them to a 306?
Im guessing id need a 20mm spacer?
Cheers.
RE: Wheel Offset Question. - Oil-burner - 17-04-2013
Depending on the width 20mm would be about right!
RE: Wheel Offset Question. - ConorTRG - 17-04-2013
Should have mentioned they are 7j wide.
RE: Wheel Offset Question. - Oil-burner - 17-04-2013
Should be fine with 20mm mate providing your beam is ok!
I always use this, you might find it useful.
Www.willtheyfit.com
RE: Wheel Offset Question. - ConorTRG - 17-04-2013
Yea beam is ok, thats a handy website, cheers mate.
RE: Wheel Offset Question. - Oil-burner - 17-04-2013
No probs mate, might be pretty close on the inside so if you can get 25mm spacers I would as they will be about 11mm closer to the inside of your arches than standard clones with 20mm spacers.
RE: Wheel Offset Question. - ConorTRG - 17-04-2013
Im still not decided if i'll go for them yet, if i went for a 25mm spacer, would i have much clearance on the outer arch, im right low so i dont want it poking out that much.
RE: Wheel Offset Question. - Oil-burner - 17-04-2013
Well im running 6.5j at et16 and theres bags of room on the back, the front is pretty close tho
RE: Wheel Offset Question. - ConorTRG - 18-04-2013
I must check tomorrow what width and offset the wheels i have on at the minute are, cause ive only a couple of mm of gap at the rear outer arch, and the fronts rub the archs when im turning (need a smaller tyre)
RE: Wheel Offset Question. - 306GT30 - 18-04-2013
7.5 ET 15 with 4mm spacer so et 9
no problem