+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: 306 Repairs & Mods (https://www.306oc.co.uk/forum/forumdisplay.php?fid=22)
+--- Forum: Guides (https://www.306oc.co.uk/forum/forumdisplay.php?fid=9)
+--- Thread: Guide: exhaust gas recirculation Valve removal EGR (/showthread.php?tid=13047)
RE: exhaust gas recirculation Valve removal EGR - Poodle - 20-06-2014
Ideally yes, else the ecu will be expecting a different amount of air and exhaust gas to go into the cylinder.
RE: exhaust gas recirculation Valve removal EGR - j77hrn - 02-08-2014
I might give this a bash later on today, cheers
RE: exhaust gas recirculation Valve removal EGR - welshpug - 02-08-2014
Definitely blank the egr, took 10min on a 110 hdi in a c5 as the manifold is a different shape, boosted so much harder after that, mpg went up to 53 on a cruise, not bad for a ton and a half of french boat
no need to disconnect any vac lines or plugs unless you map it out.
RE: exhaust gas recirculation Valve removal EGR - Toms306 - 02-08-2014
What do you guys use for gaskets on the blanks? I used a card gasket but it didn't even last a month before blowing boost and breather oil all over the bulkhead...
RE: exhaust gas recirculation Valve removal EGR - bashbarnard - 02-08-2014
You really want a proper thin metal one to be cut out. Ive used the stuff we plate sills with before works a treat. Pop to the garage mate during the week and ill have an off cut you can have
RE: exhaust gas recirculation Valve removal EGR - Toms306 - 02-08-2014
Thanks for the offer but it's going soon anyway so it'll be someone elses problem, I was just wondering what other people used.
RE: exhaust gas recirculation Valve removal EGR - cully - 02-08-2014
i used PTFE gasket materiel and cut my own
RE: exhaust gas recirculation Valve removal EGR - welshpug - 02-08-2014
just the original gasket one side and sealant the other.
RE: exhaust gas recirculation Valve removal EGR - LewisG - 02-11-2014
May be a stupid question but, if the exhaust gases arent going into the manifold, they must be going back somewhere?
RE: exhaust gas recirculation Valve removal EGR - Connor - 02-11-2014
Yes, out the exhaust where they should be
RE: exhaust gas recirculation Valve removal EGR - Piggy - 02-11-2014
Nice guide cully.
Its worth saying the 206 2.0hdi has a slightly different egr system, bloody tight down the back there! Defo a engine rocked forward job as it took me best part of an hour to blank it!!