18-07-2012, 09:47 PM
I've got a phase 3 spoiler, with a phase 2 boot. From holding it against the boot along the back there is the two points of contact, with a long gap along the middle, which i assume is for rain water to drain through and it doesn't sit flush on the corners. I don't want to hack into the strip that runs around the boot to make it sit snugger because I don't want it to leak through.
I've got a hold of some tiger seal, but don't have any experience of it so not sure how good it really is.
Got some pictures below, any advice would be greatly appreciated.
[attachment=1843]
[attachment=1844]
I've got a hold of some tiger seal, but don't have any experience of it so not sure how good it really is.
Got some pictures below, any advice would be greatly appreciated.
[attachment=1843]
[attachment=1844]