306oc - Peugeot 306 Owners Club & Forum

Will be going through some changes over the winter, but this is where its at at the moment :-)









[/url]
Re-done the carpet in the rear also gave it a quick clean :-)

[url=http://s1153.photobucket.com/user/306gtiparts/media/20161109_151406_zpshmuuzuz1.jpg.html]











Track wheels fitted ready for snetterton on sunday with another new set of AR1s fitted :-)

She's a thing of beauty! Still jealous after seeing your unit lol!

Might Well see you tomorrow, gonna try and get over to watch for a bit.

This is what I'm up against eh?

Ohh youre going to be up there tomorrow as well ryan. May come say hi. Only after meeting very breifly and seeing that epic unit of yours


Sent from my iPhone using Tapatalk

m sure yours will be much faster on the straights Sam but will be close on the corners ;-)

Yes buddy I'm there tomorrow pop up :-)

It won't be! I'll be lucky if I get a few laps in before it starts to misfire. Narrowed it down to an electrical fault either in the loom or ecu. Seems to be intermittent so probably a broken wire. Haven't got the time to build it overnight so will just have to soldier on an swap into bates 6 if it comes to it!

Cars looking well Ryan , what other plans you got for it mate

was going well on track today! Possibly better than mine Nice to meet you ryan!

This looked awesome today. Love it.

(12-11-2016, 10:18 PM)twangy Wrote: [ -> ]Cars looking well Ryan , what other plans you got for it mate

Hi buddy hope your well :-)   Over the winter im fitting a VTS 39k engine and respray under the bonnet :-)

Nice to meet you today Eeyore. Car looked good, didnt see you 1616six?

Nice seeing you again Ryan
pretty shure Sam's got some go pro footage of you giving it hell round Palmers

(13-11-2016, 09:16 PM)7057sam Wrote: [ -> ]Nice seeing you again Ryan
pretty shure Sam's got some go pro footage of you giving it hell round Palmers

You too buddy. Yeah track conditions was fun. Had it fully sideways at 90mph round corum most laps :-)

SD card has corrupted but if I can rescue it yes I have footage!

Got a little video of corum last year in the wet :-)

http://youtu.be/an0W_1cBKRk

That is FIT!

what paint are the cyclones done with?

(17-11-2016, 07:04 PM)Eeyore Wrote: [ -> ]what paint are the cyclones done with?

Its just Astor Grey, same colour i painted the Spoiler and trims with  :-)

Recently swapped the engine with a 21k VTS lump and swapped the PT81 cams over and lightened flywheel, fitted new clutch and shafts. Tidied up the engine bay. 

Looks really well Ryan , are they new speedlines you've bought for it aswell

yeh theyre the speedline ones like on the 306 BTCC but not the super duper magnesium ones. Looks really tidy Ryan. great stuff.

I see that youve carpeted the entire thing? How was that done? Just the regular trim carpet and then spray adhesive?

(20-01-2017, 08:10 AM)twangy Wrote: [ -> ]Looks really well Ryan , are they new speedlines you've bought for it aswell

Hi buddy. Yeah I bought another white rallye that had them on and there brand new ;-) do look a bit small but I like them :-)

(20-01-2017, 09:03 AM)Eeyore Wrote: [ -> ]yeh theyre the speedline ones like on the 306 BTCC but not the super duper magnesium ones. Looks really tidy Ryan. great stuff.

I see that youve carpeted the entire thing? How was that done? Just the regular trim carpet and then spray adhesive?

Yes buddy just speaker box carpet And spray glue. Weighs sod all and quietens down road noise alot. Much better than stripped out :-)

ok sounds good. I put the rear carpet in for long drives but end up with the under the rear seats section still bare.

Had a few changes in the past 3 months, now has a rebuilt Jord VTS axle with Gaz Golds and a low boost kit fitted to the low mileage VTS lump :-)

Single post... It's boosted. Haha

Nice supercharged rallye! I really like what you did with the rallye logos on the cyclones - nice touch - did you have transfers made up and then just lacquer over them, I thought these had lion logos as part of the actual alloy?!

There's a guy called Rikky who makes rallye decals I asked him to make 4 that size and using a DA took the peugeot emblem out then after the paint fitted the sticker with lacquer on top :-)

Looks really good mate , keep the updates coming

That's a nice touch DAing the alloys. Have you also fabricated rear quarter panels for the rear doors, they look really good - looks like you've got some big speakers in there too?

Rear door cards are standard with 6x9s and a mini amp builtin as I use it on the road too it's nice have a half decent sound system ;-)

Looks awsome ryan

You been out on track with it since boosting ??