Hey, does anyone know the pin out for the 3 pin temp sensor in the rad please?
Want to wire my slim line fans to cone on without switch and I've removed the original loom.
Thanks in advance
I can sort you out later, got a haynes manual for the ZX to hand ijn the workshop, nicely self contained thing connected to the shunt box, I'd get hold of another if you can.
Single speed (2 pin switch) or twin speed (3 pin switch)?
Single speed:
Pin 1 = +12v feed
Pin 3 = Fan output
Twin speed:
Pin 1 = +12v feed
Pin 2 = High speed fan output
Pin 3 = Slow speed fan output
That's going by the post-97 306 Haynes manual (see attached)
(09-05-2016, 12:34 PM)welshpug Wrote: [ -> ]I can sort you out later, got a haynes manual for the ZX to hand ijn the workshop, nicely self contained thing connected to the shunt box, I'd get hold of another if you can.
(09-05-2016, 03:09 PM)powerandtorque Wrote: [ -> ]Single speed (2 pin switch) or twin speed (3 pin switch)?
Single speed:
Pin 1 = +12v feed
Pin 3 = Fan output
Twin speed:
Pin 1 = +12v feed
Pin 2 = High speed fan output
Pin 3 = Slow speed fan output
That's going by the post-97 306 Haynes manual (see attached)
Thanks both