Just a question for you lads I've got a 307 hdi dturbo 110bhp model for spares or repairs on my drive and I was wondering if anything on that engine etc will help me towards fitting fmic on my car of so what do I need ect? Thanks
I'd keep all the intercooler pipework except for the cooler itself, the inlet elbow that connects to the inlet manifold and the lower pipe coming off the turbo
Then what else would I need etc to fot to my car? Not very clued up on this =\
An intercooler. Additional pipework. Boost gauge. MBC. Clutch if going full torque stage 2, exhaust and then the map.
I'm sure this is covered in the dw10 section tho
Plus brakes/suspension upgrades
Got a straight through and a map already, thanks for your advice pal
Well you'll need another map doing if you want decent power. Little point in putting an FMIC on if you aren't going to bother mapping it again. Have a read around the HDi section, all of this has been covered 1,000,001 times