306oc - Peugeot 306 Owners Club & Forum

Bought a strut brace from another member recently who had it fitted previously to their HDi.

It had an OMP sticker on it before I fitted it but comparing it to others online it looks nothing like what other OMP do - perhaps an older design?

I went to fit it to my car following the suspension swap and found that there was no clearance on the brake fluid reservoir - it was trying to force it downwards. I didn't want to start tightening it up as I didn't think this seemed right?

Below are some pics. The ends of the bar (where the two holes are for bolting through) have been bent in the past, suggesting that it's been pulled out of shape under force?

Have you tried putting it otherway round?

Does it not sit UNDER the edge of the res?

Tried it the other way around, bonnet would never shut like that and the holes don't line up.

It won't go underneath either piggy

Is it not a dturbo one thats designed to avoid the intercooler.

(30-03-2014, 03:05 PM)PE02KHG Wrote: [ -> ]Is it not a dturbo one thats designed to avoid the intercooler.

Possibly? Can anyone shed any light?

Even if it was the brake res are in the same place

Hmmm not a clue. Grant has one for sale cheap though that will fut as its the same as mine.

That is the rare Dturbo one.

Maybe the dturbo smaller M/C is lower??